Publicidad
STEP 23
The next steps are to assemble your electrical hardware
Cord length information:
1. The power supply cord is 72" from transformer to the plug's tip
2. The loop wire for the sensor disk, from the transformer is 48" to the center of the loop
3. The light wire that ends in a clip (that will eventually be connected to the light module),
that wire, from the transformer is 100" to the clip
4. The light module, its wire comes out of the light disk and extends out 5" to the center of its clip
Single LED Light Kit Includes:
27a. Transformer
27b. Power Supply cord
27c. Loop Sensor cord
27d. Single LED Light w/ light plug
27c
Touch Sensor Disk (separately packaged)
The Touch Sensor Disk has 3 brightness options.
- Touch 1 - night light
- Touch 2 - energy saver light
- Touch 3 - bright reading light
- Touch 4 - turn off
ameriwoodhome.com
27a
28
Please note: Assembly hardware aren't included in
these packages. But are provided in hardware bag.
33
27d
touch
sensor disk
27b
Publicidad
