Publicidad
STEP 27
(x2)
Before starting this step, the customer must decide
what side the Touch Sensor Disk (28) needs to be on.
There are two options (Left & Right). The view below
shows the right side being used.
M
When choosing the right side, place one
wire saddle (12) in the red hole as shown below.
When choosing the left side, place one
wire saddle (12) in the black hole as shown below.
Place the other wire saddle (12) in the center hole,
towards the back (black & red) as shown.
Then thread the Loop Sensor (27a) wire through
each wire saddle (12).
ameriwoodhome.com
12
touch sensor disk
M
finished edge
37
M
Publicidad
