KIKKA BOO i-TOUR Instrucciones De Uso página 6

IMPORTANT! KEEP FOR FUTURE REFERENCE!
EN
READ CAREFULLY!
I. PARTS
1.ISOFIX Insertion Aids(optional); 2. ISOFIX Fastening Points(vehicle); 3. Headrest; 4. Seat cover; 5. Shoulder pads; 6. Shoulder straps; 7. Harness buckle; 8. Crotch pad; 9. Adjustment
button; 10. Crotch strap; 11. 3600 degrees rotation adjuster; 12. Recline handle; 13. Base; 14. Bel guidance; 15. Newborn cushion; 16. Belt guidance; 17. Buckle tongues; 18. Red release
button; 19. Headrest height adjuster; 20. Instruction back cover button; 21. Shoulder belt connector; 22. Instruction back cover ( can insert instruction into it ); 23. Top Tether adjuster; 24.
Top Tether clip; 25. ISOFIX locking arms; 26. ISOFIX buttons
WARNING!
Do not use forward facing before the child's age exceeds 15 months. If the vehicle is equipped with an active front seat airbag, DO NOT use the child seat in a rearward
facing position.
1. INSTALLATION ISOFIX ( SEE FIGURES 1-7 )
1. If your vehicle is not fitted with ISOFIX Insertion Aids as standard, clamp the two ISOFIX Insertion Aids (1), which are included in the scope of delivery of the seat , with the opening
pointing upwards, to the two ISOFIX Fastening Points (2) of your vehicle. If you don't have ISOFIX Insertion Aids (1), please ignore this step.
NOTICE! The ISOFIX fastening points are located between the surface and the backrest of the vehicle seat.
2. Press the ISOFIX Buttons (26) to push out the two ISOFIX Locking Arms (25) from the seat base.
3. Push back the child safety seat until you hear a clicking sound then on both sides of the ISOFIX indicators turn into green safety color.
4. Move the child safety seat backwards to against the vehicle seat, to confirm the child safety seat is firmly against the vehicle seat.
NOTICE! Release button towards each other to loosen the ISOFIX fastening points on both sides. Move the ISOFIX locking arms back into the seat base, it can protect ISOFIX.
2. TOP TETHER
1. Pull out the top tether strap by pressing the Top Tether Adjuster (23) button.
2. Pull the top tether long enough to hang the Top Tether Clip (24) on the fixed point, which is on the back of the vehicle seat.
3. Make sure the top tether strap is tightened up and the Top Tether Adjuster (23) indicator turns into green.
3. ROTATION
1. Pull the 360° Rotation Adjuster (11) with finger , rotate the seat shell.
2. Rotate the seat shell so it is facing either forwards or backwards, depending on the height of your child, until it engages with a clicking sound.
NOTICE! When installed in forward facing position with ISOFIX and top tether(76-105cm), function of rotation may be restricted.
DANGER! When the seat is rotated to 90°, the user can place the child in this position, but user can not use this angle during driving.
4. SEAT ANGLE
The seat shell of the i-Tour can be used in 2 level position facing forwards and used in 4 level position facing backwards.
1. Pull the Recline Handle (12) and pull the seat outward,then the seat can be adjusted. It can be adjusted to 2 positions for facing forwards facing use.
Rotate the seat to the backwards direction, and the seat can be adjusted to fifth to eighth level.
40-87cm: Facing backwards installation, use fifth level to eighth level.
87-105cm: Facing backwards installation, use fifth level.
76-105cm: Facing forwards installation, use fourth level.
100-150cm: Facing forwards installation, use first level.
NOTICE! In 76-105cm, the ECRS may not fit in all vehicles varied in models, recline angles can not match vehicle seat when adjusting.
5. USING
1. Loosen the Shoulder Straps (6) by pressing the Adjustment Botton (9) and pull both Shoulder Straps (6) forwards, loosen it as much as possible.
2. Press Red Release Button (18) to open the Harness Buckle (7). Place child in child safety seat.
3. Bring both Buckle Tongues (17). Lock buckle tongues in Harness Buckle (7), until they engage with a clicking sound.
4. Pull the Headrest Height Adjuster (19), select the correct height of the Headrest (3) and engage it in position that fits your child by releasing the adjuster.
5. Adjust the Headrest (3) to proper position. Make sure the distance between child's shoulder and the bottom of the headrest is lower than one finger.
Pull the Crotch Strap (10) until the strap lies flat and snug on your child's body. Make sure that the shoulder straps slightly higher or equal to child's shoulders.
DANGER! Before each car journey, in order to ensure your child's safety, make sure that the child safety seat is fastened in the ISOFIX Fastening Points (2) on both sides with the ISOFIX
Locking Arms (25) and both ISOFIX Buttons (26) are fully green; The child safety seat is securely fastened; The harness of the child safety seat is fitted snugly to the child's body without
being constricting and should not be twisted; The Shoulder Straps (6) are correctly adjusted and the straps are not twisted; The Shoulder Pads (5) are in the correct position on your
child's body; The child safety seat is facing in the right direction for your child's age/size; The Buckle Tongues (17) are inserted into the Harness Buckle (7).
DANGER! If your child tries to open the ISOFIX buttons or the red release button, stop immediately as soon as possible. Check whether the child safety seat is correctly fastened and ensure
that your child is correctly secured. Explain to your child the dangers as sociated with their actions.
6. STORE 5-POINT HARNESS
Once the child reaches a height of 100cm, the 5-point safety harness should be stored away and the child should be secured with the adult safety-belt.
1. Open the Harness Buckle (7) as shown. Remove newborn cushion (15) and Crotch Pad (8).
2. Loosen Shoulder Straps (6).
3. Open Seat Cover (4). Re-connect the Harness Buckle (7). Hide Shoulder Straps (6) under the cover and hide the Harness Buckle (7) to the storage.
WARNING! Remove the additional seat cover accordingly when your baby above 87cm. Reattach the 5-point harness: Follow the steps for (store 5-point harness) in reverse order.
7. USING THE CHILD SAFETY SEAT. (SEE FIGURES 1-7)
Facing backwards (40-105cm) Installation
Install the child safety seat with ISOFIX+Top Tether.Hang the Top Tether Clip (24) on the fixed point, which on the back of the vehicle seat, the position of the fixed point are shown in the
picture 7.
Facing forwards (76-105cm) Installation
Install the child safety seat with ISOFIX+Top Tether Hang the Top Tether Clip (24) on the fixed point, which on the back of the vehicle seat, the position of the fixed point are shown in the
picture
DANGER!For the safety of your child, the top tether must be tightened up during driving.
ENGLISH