Publicidad
Idiomas disponibles
Idiomas disponibles
Insert the handlebar post (102) into
the hole on the main body, Fig.4.
Position it correctly and then tighten
the knob (36) by turning it clockwise.
Remove the plug (9) and loosen the
screw (18) and the cover (100). Next,
remove the side covers (101), the
screws (17), the washers (7) and the
fixing plate (16), Fig.5A.
Pass the cables (20L) and (20R)
through the fixing plate (16), Fig.5B.
Attach the handlebar (21) to the
handlebar post (102) using the fix
sheet (16), the screws (17), the
washers (7), Fig.5.
There
are
two
handlebar.
Check
suitable for the user before the next
assembly step.
Connect the cable (15) with (20L) and
(20R), Fig.5.
Attach the uper cover (100) using the
screw (18). Fit the end cap (9), Fig.5.
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (102) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (36) securely, Fig.4.
7.
Insert the iPad support tube (5) into
the handlebar post (102), Fig.6. Fit the
screws (8), the washers (7) and (6).
8.- EXERTION SETTINGS.-
To provide an even level of exertion
during
exercise,
positions
of
which
one
for
doing
this
appliance
equipped with control keys located on
the handlebar, Fig.7. To increase pedal
resistance, press the right key. To
reduce pedal resistance, press the left
key.
Important:
This item has a safety button (98), by
pressing it (as shown by the arrow in
Fig.6), there is a sudden braking effect.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet up or down.
MOVEMENT & STORAGE.-
the
The unit is equipped with wheels (80)
is
Fig.8, to make it easier to move. The
wheels located at the rear of your unit
make it easier to move it into a chosen
position, by lifting the front of the unit
up slightly and pushing it, as shown in
Fig.8. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack on the transformer into
the connection hole on the main body
and then plug the transformer (89) into
a 220V mains supply, Fig.9.
MAINTAINING THE MACHINE.-
For health reasons it is necessary to
clean the handlebars and seat after
each class with a disinfectant spray,
as well as removing any sweat from
the bicycle's frame.
is
15
Publicidad
