Publicidad
Idiomas disponibles
Idiomas disponibles
important
Notes
to the
Installer
1.
Read all instructions
contained
in these installation
instructions before installing range.
2.
Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
5.
Note: For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent for
each additional 1000 ft.
important
Note
to the
Consumer
Keep these instructions with your Owner's Guide for the
local electrical inspector's use and future reference.
IMPORTANT
SAFETY
INSTRUCTION
_l_i_lCold
temperatures can damage the
electronic control. When using the appliance for the first
time, or when the appliance has not been used for an
extended period of time, be certain the unit has been
in temperatures above 32% (0°C) for at least 3 hours
before turning on the power to the appliance.
Installation of this range must conform with local codes
or, in the absence of local codes, with the National Fuel
Gas Code ANSI Z223.1 / NFPA54 or CAN/ACG-B149.1
and CAN/ACG-B149.2.
This range has been design certified by CSA
international.
As with any appliance using gas and
generating heat, there are certain safety precautions you
should follow. You will find them in the Use and Care
Guide, read it carefully.
• Be sure your range is installed and grounded
properly by a qualified
installer or service technician.
This range must be electrically grounded in
accordance with local codes or, in their absence, with
the National Electrical Code ANSI/NFPA No. 70--
latest edition in United States or with CSA Standard
C22.1, Canadian Electrical Code, Part I in Canada. See
Grounding Instructions.
persons
could result.
Install anti-
tip device
packed with
range.
All ranges
To reduce the risk of
can tip.
tipping of the range, the
Injury to
range must be secured
by properly installed
anti-tip bracket provided
with the range. To
check if the bracket is
installed properly, grasp
the top rear edge of the
range and carefully tilt it
forward to make sure the
range is anchored.
Before installing
the range in an area covered
with linoleum
or any other synthetic
floor
covering,
make sure the floor
covering
can
withstand
heat at least 90°F above room
temperature
without
shrinking,
warping
or
discoloring.
Do not install the range over carpeting
unless you place an insulating pad or sheet of 1/4"
(10,16 cm) thick plywood between the range and
carpeting.
Make sure the wall coverings
around
the range
can withstand
the heat generated
by the range.
Do not obstruct
the flow of combustion air at the
oven vent nor around the base or beneath
the
lower
front panel of the range. Avoid touching the
vent openings or nearby surfaces as they may become
hot while the oven is in operation. This range requires
fresh air for proper burner combustion.
Never leave children
alone or
unattended
in the area where
an appliance
is in
use. As children grow, teach them the proper, safe use
of all appliances. Never leave the oven door open when
the range is unattended.
Stepping,
leaning
or sitting
on the
doors or drawers
of this range can result in serious
injuries
and can also cause damage
to the range,
Do not store items of interest
to children
in
the cabinets
above the range. Children could be
seriously burned climbing on the range to reach items.
To eliminate
the need to reach over the surface
burners,
cabinet storage
space above the burners
should
be avoided.
Adjust surface burner flame size so it does not
extend
beyond
the edge of the cooking
utensil.
Excessive flame is hazardous.
Do not use the oven as a storage space. This
creates a potentially hazardous situation.
Never use your range for warming
or heating
the
room. Prolonged use of the range without
adequate
ventilation can be dangerous.
Do not store or use gasoline
or other flammable
vapors and liquids
near this or any other
appliance.
Explosions or fires could result.
In the event of an electrical power outage, the surface
burners can be lit manually. To light a surface burner,
hold a lit match to the burner head and slowly turn
the Surface Control knob to LITE. Use caution when
lighting surface burners manually.
Reset all controls
to the "off"
position
after using
a programmable
timing
operation,
FOR MODELS WITH SELF-CLEAN FEATURE:
Remove broiler
pan, food and other
utensils
before self-cleaning
the oven. Wipe up excess
spillage. Follow the predeaning instructions in the Use
and Care Guide.
Unlike the standard
gas range, THIS COOKTOP
IS NOT REMOVABLE, Do not attempt to remove the
cooktop.
4
Publicidad
