Publicidad
Idiomas disponibles
Idiomas disponibles
Range Installation
Important
Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use and Care Guide for oven door removal
instructions.
Level the range (see section 9). The floor where
the range is to be installed must be level. Follow the
instructions under "Leveling the Range".
Slide the range into the cutout opening.
Figure 6
Standard
Installation
The range cooktop overlaps the countertop
at the
sides and the range rests on the floor. The cooktop is
311/2" (80 cm) wide.
Install base cabinets 30" (76.2 cm) apart. Make sure
they are plumb and level before attaching cooktop.
Shave raised countertop
edge to clear 311/2" (80 cm)
wide range top rim.
Install cabinet doors 31 " (78.7 cm) min. apart so as
not to interfere with range door opening.
Cutout countertop exactly as shown on page 1.
Make sure the four leveling legs are setup higher
than the height of the cabinet (shown on page 3).
Install the anti-tip
bracket
at
this point before
placing
the range at its final
position,
Follow the installation instructions on page
13 or on the anti-tip bracket template supplied with
the range.
To provide an optimum installation, the top surface
of the countertop
must be level and flat (lie on the
same plane) around the 3 sides that are adjacent to
range cooktop. Proper adjustments to make the top
flat should be made or gaps between the countertop
and the range cooktop may occur.
To reduce the risk of damaging your
appliance, do not handle or manipulate it by the
cooktop. Manipulate with care.
Position range in front of the cabinet opening.
Make sure that the underside of the cooktop clears
the countertop.
If necessary, raise the unit by
lowering the front leveling legs and the back leveling
wheels.
If Accessories
Needed
:
Installation
With Backguard
The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"
(56.2cm) Max.) needs to be increased to 24" (61 cm)
when installing a backguard.
Installation
With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation
With Side Panels
A Side Panels kit can be ordered through a Service
Center. Note: Install cabinet doors 31 " (78.7 cm) min.
apart so as not to interfere with range door opening.
Leveling
the Range
Level the range and set cooktop
height
before
installation
in the cut-out
opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see figure 7). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench.
3. Taking care to not damage the countertop,
slide
range into cut-out opening and double check for
levelness.
Figure 7
Publicidad
