cecotec POWER ESPRESSO 20 RETRO GREEN Manual De Instrucciones página 43

switch off for another 25 seconds, and so on. In this mode, the machine cannot be
put into operation.
2. After all switches have been turned to the off position, switch on the coffee maker
using the power switch. The power indicator light will slowly start flashing and the
coffee machine will start to heat up. Once it has warmed up, the power indicator
light will stop flashing and remain steady. Next, turn the coffee switch to the on
position. The coffee indicator light will start flashing slowly (approximately every 2
seconds) and the machine will start brewing coffee.
Caution: turning on the coffee switch during the preheating process of the machine will
cause the coffee indicator light to flash rapidly, indicating an error. Wait until the machine
has finished heating up and the power indicator light is steady before selecting the coffee
function.
1. Once the coffee machine has heated up, the power indicator light will remain on.
Then, turn the steam switch to the on position so that the machine continues to
heat up and starts to generate steam. The steam indicator light will start flashing
slowly. When the steam indicator is steadily lit, the steam function is ready. Then,
you can turn the knob to release the steam.
2. Press the steam switch twice within 2 seconds to activate the hot water function.
The steam indicator light will start flashing slowly (approximately every 2
seconds), indicating that you can now turn the steam knob to dispense hot water.
Caution: if, after steaming, the coffee indicator light flashes rapidly for 25 seconds and then
switches off for another 25 seconds, the machine temperature is too high. In this mode, the
machine cannot be put into operation. It will therefore be necessary to dispense hot water to
cool the coffee machine or let it cool down naturally before it can be used again.
Preheating
To make a good cup of coffee, it is advisable to preheat the coffee machine before brewing,
including the funnel, filter, and cup, so that the taste of the coffee is not altered by any cold
elements.
1. Remove the removable tank and open the cover to fill it with water, preferably
natural or purified mineral water. The water level must not exceed the "MAX" mark
on the tank. After filling the tank, put it back in place.
2. Insert the stainless-steel mesh filter into the portafilter. Ensure that the funnel
tube is aligned with the slot in the machine. Then, install the portafilter into the
coffee machine from the unlocked position by turning it counterclockwise until it
locks into the locked position.
3. Place a cup in the drip tray.
4. Plug the coffee machine into a mains socket. Make sure the steam knob is in the off
position.
POWER ESPRESSO 20 RETRO GREEN
ENGLISH
43