GE GFXP1308FWW Instrucciones De Instalación página 3

Installation Instructions
I_] LEVEL THE WASHER OR DRYER
r_ stand the washer or dryer upright. Move it
close to its final location.
r_ Make sure that the washer or dryer is level by
placing a level on top. Check side to side and
front to back.
B]
/
Use an open /
./
ended wrench to
adjust the legs in
and out. Tighten
the lock nut
against the
bottom of the
pedestal.
NOTE: To minimize vibration, the locking nuts must
be tight.
[_] REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the
washer.
r_1 FINALIZE THE INSTALLATION
Refertothewasher or dryerInstallation Instructions
tocomplete theinstallation.
[_] REINSTALL THE DRAWER
r_ Check to be sure the slides are closed.
r_ Slide the drawer into the opening. Align the
drawer supports to the slides on each side.
r_ Reinstall the original screws into each drawer
slide. Tighten both screws.
r_ open the drawer fully. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.