Publicidad
WARNINGS
The exclamation point within the triangle is a warning sign alert-
ing the user of important instructions accompanying the
product.
The lightening flash with arrowhead symbol within the triangle
is a warning sign alerting the user of "dangerous voltage" inside
the unit.
To reduce the risk of electric shock, do not remove the cover. No
CAUTION
user serviceable parts inside the unit. Refer all servicing to
RISK OF ELECTRIC
SHOCK
qualified personnel.
DO NOT OPEN
230v~
This unit operates on 230V ~ 50Hz. If the unit is not used for a
long period of time, remove the plug from the AC mains.
Make sure all batteries are inserted according to the proper
-
+
polarity. Do not mix old batteries with new ones.
If the unit is not used for a long period of time (more than 1
-
+
month), remove all batteries from their compartment to avoid
possible leaking.
This unit must not be exposed to moisture or rain.
The power switch in this unit is mounted on the secondary
circuit and does not disconnect the whole unit from the mains in
OFF position.
Ensure all connections are properly made before operating the
unit.
This unit should be positioned so that it is properly ventilated.
Avoid placing it, for example, close to curtains, on the carpet or in
a built-in installation such as a bookcase.
Do not expose this unit to direct sunlight or heat radiating sources.
1
English
1
2
CONNECTING TO POWER
Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
Caution
To prevent electric shock disconnect from the mains before removing cover. No user
serviceable parts inside. Refer servicing to qualified service personnel.
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: AC230Volts / 50Hz - AC only
BATTERY OPERATION
•
•
•
RADIO OPERATION
1.
2.
3.
4.
CLOCK AND ALARM OPERATION
SETTING THE CLOCK
Make sure the POWER switch (4) is set to the 'Off' position. The time or alarm time cannot
be set or adjusted while the unit is 'On'.
Press and hold the CLOCK (7) button and the siaplay will show 00:00. The first 00 will flash,
then press UP / DOWN (8-9) to select the correct hours.
Press the CLOCK (7) button to confirm the hour setting, then the minute 00 will flash and
press Skip UP / DOWN (8-9) to select the minute.
Press the CLOCK (7) button to confirm the minute setting.
English
This symbol means that this unit is double insulated. An earth connection is not
required.
Open the Battery Compartment (8) at the rear of the radio and insert four UM-2 batteries
following the polarity diagram shown inside the battery compartment.
Batteries should be removed form the compartment if the unit is not to be used for
some time.
Flat batteries should be removed from the unit to avoid leakage.
Move the Function Knob (4) and select the RADIO mode.
Move the radio wave band (AM or FM) using the BAND Button (3)
Search for the station of your choice using the Tuning knob (2).
To switch off the radio, Move the Function Knob (4) and select POWER OFF
Publicidad
