Installation Procedure; Care & Cleaning - Toto Aquia TS416C2 Manual De Instrucciones Y Del Propietario

INSTALLATION PROCEDURE

1) Confirm that the valve has been
installed properly.
NO TE: The finished wall surface
should be between the min
and max markings on the
plaster guard. See the TS2A/
TS2D installation manual for
further information.
2) Remove the four screws secur-
ing the plaster guard to the
valve body, then pull the plaster
guard outwards to remove it.
3) Remove the short screw inside
the valve stem, leaving the valve
stem in place.
Slide the valve stem extension
over the valve stem and secure it
with the long screw and washer
(included with the trim set).
Install the threaded base onto
valve body with the included 4
screws.
4) Install the faceplate on the wall,
centered around the threaded
base, with the "Close" markings
at the top.
Make sure that the gasket is
seated in the groove on the back
of the escutcheon.
Screw the escutcheon onto the
threaded base and tighten it
against faceplate.
Max 95 mm (3 3/4")
Min 65 mm (2 1/2")
Plaster Guard
Finished Wall
Volume Control
Valve
Valve Body
Plaster Guard
Screws
Long Screw
& Washer
Threaded
Base
Valve Stem
Extension
Finished Wall
Faceplate
Escutcheon
4
Installation Procedure (continued)
5) Push the volume knob fully onto the
valve stem extension, with the set
screw hole on the bottom.
Measure the distance "X" from
the bottom edge of the handle to
the flat on the escutcheon. Then
compare that measurement to the
following table to determine where
to cut the valve stem extension.
Cut the valve stem extension and
remove any burs with a file.
X
0" to 1/4" (6 mm or less)
1/4" to 7/16" (7 mm to 11 mm)
7/16" to 5/8" (16 mm to 12 mm)
5/8" to 13/16" (17 mm to 21 mm)
13/16" to 1" (22 mm to 26 mm)
1" to 1-1/4" (27 mm to 31 mm)
1-1/4" or more (32 mm or more)
6) Turn the valve stem extension counter-
clockwise until it stops.
For valve TS2A: Install the volume control
knob onto the valve stem with the set
screw located at the bottom.
For valve TS2D: Install the volume control
knob onto the valve stem with the set
screw hole located on the right.
Tighten the set screw and rotate the
volume control knob clockwise to check
its operation.
CARE & CLEANING
Your new trim is designed for years of trouble-free performance. Keep it
looking new by cleaning it periodically with mild soap, rinsing thoroughly
with warm water and drying with a clean, soft cloth. Do not use abrasive
cleaners, steel wool or harsh chemicals, as these will dull the finish. Failure
to follow these instructions may void your warranty.
X
Cut stem extension
at point:
Do not cut
A
B
C
D
E
F
Volume Control
Knob
Set Screw
Hex
Wrench
5
A
B
C
D
E
F