Publicidad
Idiomas disponibles
Idiomas disponibles
FR 200 • Operating Manual
Choosing the type of cutter. For examples, See chapter "Tools" on page 9
Mount the same number of cutters and spacers on the flail shaft.
An improperly proportioned configuration of cutters and disks results in an imbalance of
the drum and premature wear.
Use only cutters which are worn to the same extent.
The cutter tools must not be mixed on a single tool drum.
Milling cutters must not contact the drum flange and the drum segment bridges.
When fitting milling cutters or clover leaf cutters, make sure that the cutter tools rotate in
the correct direction.
Fitting out the flail shafts
4. Push the flail shaft in until it is immediately in front of the segment bridge on the drum flange.
5. Fit the flail shaft with cutters and spacers.
6. Fit the next flail shaft with cutters and spacers until the tool drum has been completely
fitted out.
7. Insert the retaining ring on the drum flange.
8. Secure the retaining ring with hexagon bolts on the drum flange.
D
G
E
H
Operation
F
17
Publicidad
