Giropes Baxtran BS-TRI Manual De Usuario página 12

Press key, display shows "UnLD", empty the platter, after STABLE indicator on. Press
display shows the calibrate weight, you can press
press key,put the calibrate weight on, after STABLE indicator on, press
shows "PASS", then come back to setting mode , the calbration is finished.
7.3 CHANGE RESOLUTION*
After enter setting mode, the display shows "F0 CAL", press
key to enter, press
7.4 CHECK INTERNAL COUNTS
After enter setting mode, display shows "F0 CAL", press
key to enter, display shows internal counts, press
7.5 SET THE LOCAL GRAVITY*
After enter setting mode, display shows "F0 CAL", press
key to enter, Press
setting mode.
7.6 SET AUTO POWER OFF
After enter setting mode, display shows "F0 CAL", press
key to enter, press
7.7 CHANGE CAPACITY*
After enter setting mode, display shows "F0 CAL", press
key to enter, press the
7.8 SET CHECKING WEIGHING FUNCTION
After enter setting mode, display shows "F0 CAL", press
key to enter, press
7.9 SET BEEP MODE
After enter setting mode, display shows "F0 CAL", press
key to enter, press
7.10 SET A/D SPEED
After enter setting mode, display shows "F0 CAL", press
key to enter,press
7.11 SET MULTI-TARE FUNCTION*
After enter setting mode, display shows "F0 CAL", press
key to enter, press
12
key to select increment, press
key to change the value, press
key select the auto power off time (0, 3, 5,15,minutes), press
key change current capacity.
key select the checking weighing function on/off, press
key select the beep mode (0,1,2), press
key select the A/D speed (7.5/15/30), press
key select Multi-Tare function on/off. press
USER'S MANUAL BS-TRI
key to select calibrate weight, after you select,
key, display shows "F1 res", press
key to sure.
key until display shows "F2 INP", press
key to return setting mode.
key until display shows "F3 grv", press
key to shift location. press
key until display shows "F4 OFF", press
key until display shows "F5 CAP", press
key until display shows "F6 ck", press
key until display shows "F7 bep", press
key to sure.
key until display shows "F8 SPD", press
key to sure.
key until display shows "F9 tar", press
key to sure.
EN EN
key again,
key to sure, display
key to return
key to confirm.
key to sure.