GE AEN10 Serie Manual Del Propietario Y Instrucciones De Instalación página 4

About the controls on the air conditioner
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
The display always shows
the room temperature
except when setting the
Set temperature or the
Delay timer.
Light indicates the unit
is in the temperature or
delay time Set mode.
Lig : indicates the delay timer is set.
Air Conditioner
Controls
Controls
O ower Pad O
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Q
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Settemperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
NOTE:The display will change to show the room
temperature after settings have been made.
To recall the Set temperature, press the Temp
Increase Aor Decrease vpads.
Temp Increase A/Decreasev Pads
Useto set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase A(+)/Decreasev(-)
Pads
Eachtouch of the Increase A/Decrease • pads
on the unit or the Increase + / Decrease - pads
on the remote control will set the delay time
when using the Delay 1-24hr timer (+).The Set
light will turn on while setting.
O Fan Speed Pads
Useto set the fan speed to Low, Med, High
or Auto on the unit. NOTE:On the remote
control, use the fan speed Increase + /
Decrease - pads to set the fan speeds to Low,
Med or High. Usethe Auto pod to turn Auto
fan on.
Mode Pad
Useto set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads
Delay ON--When the air conditioner is off, it can
be set to automatically come on in 1 to 2/4hours
at its previous mode and fan settings.
Delay OFF--When the air conditioner is on,
it can be set to automatically turn off in J_ to
2/4hours.
How to set:
Pressthe Delay 1-24hr pad on the unit or the
+ pad on the remote control. Each touch of the
Increase A/Decrease •pads on the unit or the
Increase + / Decrease - pads on the remote
control will set the timer in 1-hour intervals. The
Set light will turn on while setting.
To review the remaining time on the Delay
1-24hr timer, press the Delay 1-24hr pad on the
unit or the + pad on the remote control. Usethe
Increase A/Decrease •pads on the unit or the
Increase + / Decrease - pads on the remote
control to set a new time if desired.
To cancel the timer, press the Delay
1-24hr pad until the light on the Delay 1-24hr
pad goes off.
4
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. If the Delay 1-24hr
feature was set, it will resume countdown. You may
need to set a new time if desired.