GE AEN10 Serie Manual Del Propietario Y Instrucciones De Instalación página 9

Installation Instructions
[] WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window. You will need to modify
them for other types of windows.
CAUTION: Ifthesill
s upport
bolts do not contact the window sill, or
if you have u window without u sill, you
must order accessory kit RAK87 to
properly install this air conditioner.
Cull 800.626.2002 or visit GEAppliunces.com.
• The air conditioner can be installed without
the accordion panels if needed to fit in a
narrow window. See the window opening
dimensions.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within reach of
the power cord.
I
I
16.4" min.
25.25" to 38"
(With accordion panels)
t"
I
IY1 STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the sill.
WOOD PIECES -
WIDTH: 2"
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the sill to make it 1/2" higher
than the top of the storm window frame or the
vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
1/2" higher
than vinyl frame
___ _ (on some windows)
L- K" Wood
- r v Vinyl frame I I
I_ REMOVE THE AIR CONDITIONER
FROM THE CASE
[] Remove and save the 2 screws from the lower
sides of the front grille.
%
FRONT
Grasp the lower corners of the grille while
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3" or you may damage the tabs of
the grille.
"I t
FRONT
[] Remove the ground screw from each side of
the case. Keep them in a safe location.
NOTE: Be sure to save these screws. You will
need them later in the installation.
FRONT
r_ Slide the air conditioner from the case by
gripping the base pan handle and pulling
forward while bracing the case. Do not pull or
lift on the styrofoam discharge area.
Do not
pull or
in this
damage
to the
unit may
result
FRONT