Publicidad
Idiomas disponibles
Idiomas disponibles
IS THERE A PROBLEM?
Problems
Possible Causes Solutions
The steam station does
The appliance is not
not switch on or the iron
switched on.
indicator and ON/OFF
indicator do not switch on.
Water runs through the
You use steam too
holes in the soleplate.
frequently when your iron
is not hot enough.
Water has condensed in
the pipes because you are
using steam for the first
time or you have not used
it for some time. you have
not used it for some time.
Water streaks appear on
When taking a break from
the linen.
ironing, if your ironing
board cover is soaked with
water it is not suited to the
power of a steam station.
White streaks come
Your boiler has a build-up
through the holes in the
of scale because it has not
soleplate.
been rinsed out regularly.
Brown streaks come
You are using chemical
through the holes in the
descaling agents or
soleplate and stain the
additives in the water for
linen.
ironing.
The soleplate is dirty or
You are ironing at too high
brown and may stain
a temperature.
the linen.
Your linen is not rinsed
sufficiently or you have
ironed a new garment
before washing it.
You are using starch.
There is no steam or
The water tank is empty
there is little steam.
(red light flashing).
The soleplate temperature
is set to the maximum.
The water tank is not
correctly fitted into its
housing.
Check that your appliance is correctly
plugged in and press the illuminated on/
off button.
Wait for the thermostat light to go out
before activating the steam trigger.
Adjust the frequency of use of the steam
trigger to match the position of the
thermostat (see § 6).
Press on the steam trigger away from your
ironing board until the iron produces steam.
Check that your ironing board is suitable.
A mesh type ironing board must be used
avoid condensation.
- Rinse the collector when the "Calc Away
OK button" indicator flashes.
- Rinse the boiler twice a year.
If your water is very hard, rinse it more often.
Never add this type of product to the water
tank (see § 2).
Contact an Approved Service Centre.
See our recommendations regarding
temperature control setting.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garments which may be sucked up by the
iron.
Aways spray starch on the reverse side of
the fabric to be ironed.
Fill the water tank and press the "OK"
button on the control panel.
The station is working but steam is very hot
and dry. As a result, it is less visible.
Push it into position until it «clicks» into
place.
12
Problems
Possible Causes Solutions
steam comes out from
collector is not tight
around the collector.
enough.
The seal of the collector is
damaged.
The station is faulty.
The red "water tank
You did not press the
empty" light flashes.
"OK" button.
Steam or water escapes
The station is faulty.
under the appliance.
The orange"Calc Away
You did not press the
OK button" light is
"OK" button.
lighting
Tighten the collector after having let the
appliance cool for 2 hours.
Contact an Approved Service Centre.
Stop using the station and contact an
Approved Service Centre.
Press the "OK" button on the control panel
until the indicator goes out.
Stop using the station and contact an
Approved Service Centre.
Press the "OK" button on the control panel
until the indicator goes out.
13
Publicidad
