Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
STEP 4
CONNECT RANGE TO GAS
WARNING
Do not use a flame to check for gas leaks.
Assure that gas supplg is turned
off
at the shut-off
valve:
• Apply pipe thread sealant to the gas inlet located
at the back of the range. Install the 1/2" pipe
elbow (provided) to the gas inlet.
• Connect 5/8" O.D. flexible metal connector
to gas inlet. Connect the other end of the flexible
connector
to the house gas supply.
• Turn on the gas and check for leaks:
- Use a liquid leak detector
at all joints
and connections
in the system.
IMPORTANT: Disconnect the range and the
individual
shut-off valve from the gas supply piping
system during any pressure testing of that system
at test pressures greater than 1/2 psig. Isolate the
range from the gas supply piping system by closing
the individual
manual shut-off valve to the range
during any pressure testing of the gas supply piping
system at test pressures equal to or less than
1/2 psig.
NOTE: This range is equipped with a gas shut-off
valve located on top of the range, beneath
the rear
vent. This shut-off valve is to be used in the event
that service is required in the future.
STEP 6
ROLL RANGE INTO POSITION
AWARNING
The Anti-Tip Bracket must be properly
installed
to prevent tipping of the range. Failure to do so
can cause serious damage or injury.
• Check to be sure the appliance
runners are
beneath the wheels.
• The range is shipped with the wheels in the down
position. Carefully
roll the range into position,
being careful not to entangle or pinch the power
cord and flexible gas tubing.
• Remove the runners beneath the range.
Be sure Anti-Tip
Bracket is engaged
with the brace
on the range.
STEP 5
CONNECT ELECTRICAL
• Plug power cord into properly
grounded
receptacle.
• Verify that power is connected
by opening
the oven door or press the button on the left side
of the control panel to illuminate
the accent
lighting.
14
Publicidad
