Publicidad
Idiomas disponibles
Idiomas disponibles
Once regulator i sin place, o penthe shutoffvalve in the
gassupply line.Waita few minutes f or gasto move
through thegasline.
Leaktesting of the applianceshallbe conducted
accordingto the manufacturer's instructions,
Check f orleaks. A fterconnecting therange t othegas supply,
check t hesystem forleaks w itha manometer. Ifa manometer
isnotavailable, turnonthegassupply a nduse aliquid leak
detector atall j oints andconnections
tocheck f orleaks.
Donot usea flameto check for leaks
fromgasconnections. Checking f or leaks witha flame
mayresultin afire or explosion.
Allopenings inthewallor floorwhere the range isto be
installed mustbesealed.
Moving
the Appliance
for
Servicing
and Cleaning
Turn off the range line fuse or circuit breakers at the main
power source, and turn off the manual gas shut-off valve.
Make sure the range is cold. Remove the service drawer
(warmer drawer on some models) and open the oven door.
Lift the range at the front and slide it out of the cut-out
opening without creating undue strain on the flexible gas
conduit. Make sure not to pinch the flexible gas conduit at
the back of the range when replacing the unit into the cut-
out opening. Replace the drawer, close the door and switch
on the electrical power and gas to the range.
Tighten
all connections
if necessary to prevent gas
leakage in the cooktop or supply line.
Disconnect
this range and its individual
shutoff
valve from the gas supply piping system during any
pressure testing of the system at test pressures greater
than 1/2 psig (3.5 kPa or 14"(35,56 cm)water column).
Isolate the range from the gas supply
piping system
by closing its individual manual shutoff valve during any
pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psig (3.5 kPa or
14"(35,56 cm) water column).
LP/Propane
Gas Conversion
This appliance can be usedwith Natural gas or LP/Propane
gas. It is shipped from the factory for use with natural gas.
If you wish to convert your range for use with LP/Propane
gas, use the supplied fixed orifices located in a bag
containing the literature marked "FOR LP/PROPANEGAS
CONVERSION." Follow the instructions packaged with
the orifices.
The conversion must be performed by a qualified service
technician in accordance with the manufacturer's
instructions and all local codes and requirements. Failure
to follow these instructions could result in serious injury
or property damage. The qualified agency performing
this work assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in personal injury and property
damage.
9
Publicidad
