Publicidad
4. Install the center cover (D) on the steering wheel.
The center cover is attached with snap locks.
To install the knob on the throttle
control
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
1. Put the knob (A) onto the throttle control lever.
A
C
2. Install the nut (B) and the screw (C).
To install the seat
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
1. Hold the seat in position and install the 2 screws (A)
and the 2 nuts (B).
A
2. Do a check of the operator presence control. Refer
Operation conditions on page 10 .
to
WARNING:
product if the operator presence control
is defective.
To adjust the seat
1. Fold the seat forward.
14
B
A
B
Do no operate the
2. Loosen the 2 quick knobs.
3. Move the seat until it is in a position where you can
push the pedals down fully.
4. Tighten the 2 quick knobs fully.
To install the tow bar
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
•
Install the tow bar with the 2 screws.
To install the anti-scalp wheels
Assembly overview on page 13 for the correct
Refer to
fasteners for this task.
•
Install the anti-scalp wheel (A), the bushing (B), the
washer (C), the bolt (D), and the nut (E) in 1 of the 3
holes.
A
C
D
E
B
2117 - 003 - 16.01.2024
Publicidad
