Publicidad
a) Remove the clip (A) and the washer (B).
b) Disconnect the front link (C) from the bracket (D)
on the cutting deck.
8. Do the steps that follow to disconnect the 2 rear
links. There is one rear link on the left side and one
rear link on the right side of the product.
WARNING:
heavy. Use a crowbar or equivalent
below the cutting deck to hold the weight
of the cutting deck when you disconnect
the 2 rear links.
a) Remove the clip (E), the washer (F) and the pin
(G) from the left rear link.
G
E
F
b) Disconnect the cutting deck from the left rear
link.
c) Pull and hold the cutting height lever in the
lowest position with one hand. Remove the clip,
the washer and the pin from the right rear link.
WARNING:
cutting height lever. The mechanism
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury if you
do not pull and hold the cutting
height lever.
d) Disconnect the cutting deck from the right rear
link.
e) Carefully release the cutting height lever.
26
B
A
C
D
The cutting deck is
Do not release the
WARNING:
for the cutting height adjustment is
spring-loaded. The force from the
spring can cause crush injury. Keep
body parts away.
9. Move the cutting height lever to the highest position.
10. For the TS 112 model, do the steps that follow to
disconnect the clutch cable.
a) Disconnect the clutch cable (H) from the spring
(I) on the belt tensioner.
b) Remove the clip (J) and pull out the clutch cable
holder (K) from the bracket on the cutting deck.
J
11. Remove the cutting deck from the product.
12. Install the cutting deck in the opposite sequence.
CAUTION:
belt is installed correctly and does not
get compressed when you install the
cutting deck.
The mechanism
I
H
K
Make sure that the drive
2117 - 003 - 16.01.2024
Publicidad
