Beko BBUE1134T0XMP Instrucciones De Instalación página 8

• The product must be connected to the
mains supply only by an authorised and
qualified person. The product's warranty
period starts only after correct installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
• The appliance must be installed so that
it can be completely disconnected from
the mains supply. The separation must
be provided by a switch built into the
fixed electrical installation, according to
construction regulations.
• The rear surface of the oven and the
bottom surface of the hob get hot
when it is in use. Make sure that the
electrical connection does not come into
contact with the rear surface otherwise,
connections can get damaged.
• The connection cable must not be
clamped, bent or trapped or come into
contact with hot parts of the appliances.
You may cause the appliances to short
circuit and catch fire as a result of the cable
melting. If the power cord is damaged, it
must be replaced by a qualified electrician.
Otherwise there is a risk of electric shock,
short circuit or fire!
• The plug of the power cord should be
easily accessible after installation (but not
over the hobs).
• When wiring, you must comply with
national / local electrical regulations and
use socket outlet / line and plug suitable
for the appliances. If the power limits of
the product exceed the current carrying
capacity of the plug and socket outlet /
line, you must connect the product directly
to the fixed electrical installation without
using the plug and socket outlet / line.
• Make sure that fuse rating is compatible
with the product.
• Connection must comply with national
regulations.
• The mains supply data must correspond to
the data specified on the type label of the
products. You may see the hob's type label
on the bottom of the hob and open the
oven door to see the oven's type label.
• Power cable of your product must comply
with the values in "Technical specifications"
table.
• If the product will be connected directly
to the supply power: If it is not possible
8
to disconnect all poles in the supply
power, a disconnection unit with at least 3
mm contact clearance (fuses, line safety
switches, contactors) must be connected
and all the poles of this disconnection
unit must be adjacent to (not above) the
product in accordance with IEE directives.
Failure to obey this instruction may cause
operational problems and invalidate the
product warranty.
• Additional protection by a residual current
circuit breaker is recommended.
If the product is produced with cable:
• Connect the cord of product to supply
power as identified below:
If your supply cord type is 5-conductor type,
for 3-phase connection:
- (BRW) Brown = L1 (Phase)
- (BLA) Black = L2 (Phase)
- (GRE) Grey = L3 (Phase)
- (BLU) Blue = N (Neutral)
- (GR/YE) Green/yellow wire = (E)
(Earthing)
3 N AC 380-415 V
If the product is produced without
cable:
A power cable that it is defined in the
technical table home must be connected to
product by following the instructions. Power
cable must not be longer than 2 m because
of safety reasons.
• Open the terminal block cover with a
screwdriver.
• Insert the power cable through the cable
clamp below the terminal and secure it to
the main body with the integrated screw on
cable clamping component.
BRW
L1
BLA
L2
GRY
L3
BLU
N
E
GR/YE