Publicidad
Idiomas disponibles
Idiomas disponibles
10. Automated Learning Process./Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this
REMOTE CONTROL
is not desired, turn wall switch off to any other
TRANSMITTER
programmable receiver or fan.
(back side)
Remove battery cover on back side of remote
control transmitter. Install one 12-volt battery
(included).
WARNING: Battery is to be inserted with the
correct polarity.
SET button
Restore electrical power. Within 60 seconds of
restoring the power, press and hold the SET
SET
button for 5 seconds or until light blinks twice.
Then replace the battery cover.
battery
NOTE: Remove battery with low or no charge
and dispose of properly.
IMPORTANT: Store the remote control
transmitter away from excess heat or humidity.
battery cover
To prevent damage to remote control
transmitter, remove the battery if remote
control transmitter will not be used for long
periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK. " -
When disposing of household alkaline
I I I
IV
batteries, it is best to check with your local and
V
I I
state recycling or household hazardous waste
VI
I
coordinators concerning the specifics of the
program in your area. You may also locate a
recycling center by calling 1-800-8-BATTERY or
1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
REMOTE CONTROL
WARNING: Choking Hazard - Small parts.
TRANSMITTER
Keep battery away from children.
(front)
WARNING: Battery is NOT rechargeable. A
non-rechargeable battery is not to be
recharged.
page 10
Publicidad
