Craftmade Hogan HGN54 Guia De Instalacion página 9

9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor housing
to come through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw that was
just removed and securely tighten all 3 screws
with a Phillips screwdriver.
Remove the 3 screws located on the underside of
the fitter plate.
WHITE
Connect wire from motor housing to
WHITE wire from LED light kit. Connect
BLACK) wire from motor housing to
from LED light kit. Be sure molex connections
snap together securely.
Carefully arrange wiring within fitter plate. Align
holes on the outer rim of the LED light kit with
corresponding holes in fitter plate. Re-insert the
3 screws that were previously removed and
tighten all 3 screws securely.
If you wish to USE the light kit, align grooves on
shade with nodules on inside of fitter plate and
push up gently on shade. Turn shade to the
RIGHT (clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make sure
shade is secure.
If you do NOT wish to use the light kit,
grooves in metal cover with nodules on inside
of fitter plate. Push up on metal cover and then
turn metal cover to the
no longer turns.
WARNING: Metal cover will be HOT if light is left
on.
BLUE (or
BLUE wire
align
RIGHT (clockwise) until it
motor
plate
fitter
plate
molex
connections
molex
connections
LED light kit
shade
LED light kit
metal cover
page 9
motor
housing
motor
housing
fitter
plate
LED light kit
motor
housing
fitter plate
nodule
groove
motor
housing
fitter plate
nodule
groove