Craftmade Hogan HGN54 Guia De Instalacion página 8

7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
protrusions on canopy cover with knotches in
the hole in the bottom of center of the canopy.
Press up gently but firmly on the canopy cover
until it fits into the bottom of the canopy and
then turn canopy cover to the right (clockwise)
about 1/2 in.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 18 blade screws and washers in
hardware pack. Slide a blade through one of
the narrow, rectangular openings on motor
housing, aligning holes in blade with holes in
blade arm (located on the underside of the
motor housing)--refer to drawing at right.
Insert 3 blade screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
procedure for each remaining blade.
NOTE: Tighten blade screws twice a year.
canopy
screw
blade
arm
page 8
hanging
bracket
screw
canopy cover
motor
housing
blade
blade screws and washers