Publicidad
Idiomas disponibles
Idiomas disponibles
13. START PROCEDURE
IMPORTANT
INITIAL START PROCEDURE
A. The Electronic Interface display should show the message "READY TO START";
B. Press the green key to start the compressor, and immediately press the emergency button (turning off the compressor - vide item stop
procedure), observing if the rotation direction of the assembly is the same as that of the arrow located on the housing of the compressing
assembly and the rotation direction of the fan (the correct air flow is towards the heat exchanger);
Note: In case the direction is wrong, disconnect the compressor from the mains and invert the wires in the input of the power supply or at
the output of the protection fuses and repeat the procedure B. And for the fan, invert only the two cables of contactor of fan.
Note: Unlock the emergency button and press the reset key on the controller to cancel the message "EMERGENCY" in the display, which
afterwards will show "READY TO START".
C. After making sure the rotation direction is correct, close the side door and press the ON (green) key to put the compressor into operation,
with the valve closed until the compressor reaches the maximum pressure. Slowly open the valve and your air compressor will be ready to
supply compressed air to the compressed air system.
Note: The air dryer should be already on.
IMPORTANT
Troubleshooting.
- In normal situations, use the OFF (red) key in the instrument panel.
- The emergency button must only be used when a fast deactivation of the compressor is desired. Its use in normal conditions will cause
failure of the equipment which is not covered by the Warranty.
14. STOP PROCEDURE
• The compressor is programmed to turn off according to the setting of the controller;
• In order to turn it off (manual stop), press the OFF (red) key in the instrument panel.
• For emergency stops, press the emergency button. The stop of the compressor will be fast.
Before start up the compressor. check if the hoses and electrical contacts are tightened.
- Do not allow, at the first start, the air end to run for over 3 (three) seconds with the wrong rotation. The
operation of the item B is quick and easy to see. If there are difficulties in the start, refer to the chapter
71
Publicidad
