Descargar Imprimir esta página

Triton TPT 125 Instrucciones De Uso Y De Seguridad página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 66
2. Position the blade so that it sits securely on the two pins
3. Use the Magnets to transfer the cover plate back onto the blades
4. Re-fit the cover plate so that the six fixing holes are aligned with
the holes on the cutter head
5. Tighten and secure with the six bolts
Inspecting and replacing the second blade:
1. To access the other blade, gently pull and hold the latch on the
side of the cutter head to release it (Image H)
2. Once the cutter head rotates, release the latch
3. Without touching the blades, carefully turn the cutter head until
the self-engaging latch clicks to lock the head again
4. Repeat the blade-changing procedure to check and replace the
second blade
Checking and replacing the brushes
• Over time the carbon brushes inside the motor may become
worn
• Excessively worn brushes may cause loss of power, intermittent
failure, or visible sparking
• Brush life varies, depending on the motor loads. Inspection of
the brushes after every 100 hours of use is recommended
• Replace the brushes if the length of carbon has been worn
to less than 9.5mm, or if the springs are worn, or if you have
noticed a loss of performance in the motor
• Replace with new parts only, and always replace both brushes
• To inspect and replace the brushes:
1. Unscrew the Brush Access Caps (14) on either side of the
motor
2. Remove the brushes and check for wear
3. Insert new brushes if required, and re-fit the brush caps
Replacing the drive belt
• Inadequate tension in the belt drive will cause the belt to slip. A
loose belt must be replaced
1. Switch the thicknesser 'OFF' and remove the plug from the
power source
2. Remove the Crank Handle (9), then loosen and remove the Side
Panel Retaining Screws (2) (Image I) so that you can move the
side panel out of the way. This will allow access to the belt drive
(Image J)
3. Remove the upper pulley cover (Image K)
4. Remove the old belt by alternately walking the belt off each
of the pulleys. Gently pull the belt outward while turning the
pulleys at the same time (Image L)
Note: To turn the drive belt pulleys, it will be necessary to hold the
EN
red self-engaging latch, so the pulleys do not become locked into
place.
5. Replace with a new belt by walking the belt onto the pulleys in
the reverse manner used for removing the worn belt
6. Ensure the belt is evenly seated on the pulley grooves
7. Replace and secure the side panel and Crank Handle
12
Storage
• Store this tool and its accessories after use in its case in a dry,
secure place out of the reach of children
Contact
For technical or repair service advice, please contact the helpline on
(+44) 1935 382 222
Web: tritontools.com/en-GB/Support
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.,
Holtum-Noordweg 11,
Unit 4,
6121 RE Born,
Netherlands
Disposal
Always adhere to national regulations when disposing of power tools
that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the
correct way to dispose of power tools

Publicidad

loading