Installation; Placement And Mounting; Input Signal Sources - Ecler SMAC PRO30 Manual De Instrucciones

3. INSTALLATION

3.1. Placement and mounting

The first thing to take into consideration when placing your SMAC is your comfort and an
easy access to all the connections.
The SMACs is basically conceived as a tabletop mixer and its usual placement will be
between two vinyl or CD players.
The optional metallic LSMAC side profiles kit allows you to firmly fix your SMAC to the
surface over which it is placed or over its own profiles (Fig.1).
These profiles also allow to tilt the mixer's position for an easier operation.
Remember that the SMAC mixers have connectors in the front of the box and an external
connection must be provided when the unit is mounted on a rack.
Because of the high gain of the PHONO and MICROPHONE inputs, always try to place
the mixer as far away as possible from noise sources (dimmers, engines, etc...) and mains wires. For
the very same reason, and under any circumstance, should you ever remove the unit's metallic
cover.
The power consumption of the SMACs is very low, so they don't need any cooling, but you
should avoid extreme temperatures and the atmosphere should be as dry and dust-free as possible.
The SMAC PRO30 operates under voltages between 90 and 264 V at 47 to 63 Hz. This
device features an over dimensioned power supply that adapts to the mains voltage in any country of
the world with no need to make any adjustments. Make sure that the mains wire (which plugs into
32) is far away from the signal cables in order to avoid any possible audio hum.
In order to protect the unit from an eventual electrical overload it carries a 500mA fuse
(32). Should it ever blow up, unplug the unit from mains and replace it with an identical one. If the
new fuse blows again contact immediately with our Authorized Technical Service. YOU MUST
NEVER USE A HIGHER VALUE FUSE.
CAUTION: Fuse substitutions have to be performed by a qualified technician.

3.2. Input signal sources

-Turntables: They must be fitted with magnetic cartridges of 1 to 100mV nominal output
level. The PHONO inputs (25) of the SMACs have a very good headroom so they can accept high
output level cartridges. If you use moving coil cartridges they must be of high output level type and a
transformer or external preamplifier, placed as near as possible to the turntable, must be connected
between the cartridge and the mixer.
-Microphones: The Mic inputs (1-33), have a nominal input level of 0'316 to 31'6mV and
are equipped with XLR 3 and 1/4" jack connectors.
These inputs allow for the use of balanced wires. Connections are as follows:
HOT or direct signal
COLD or inverted signal
GROUND
Low impedance (200 to 600) monophonic microphones must be used. Shortcircuit pins 1
and 2 of the XLR connector or use a mono jack whenever an UNbalanced connection is desired. An
stereo jack can also be used for UNbalanced connections if the ring is shorted to ground.
XLR 3
> Terminal 2
> Terminal 3
> Terminal 1
1/4" jack
Tip
Ring
Sleeve
5