External Effect Output, Eff; Crossfader Assignement; Crossfader Curve Adjust; Effects: Kill, Punch - Ecler SMAC PRO30 Manual De Instrucciones

1.- Remove external screws of the module.
2.- Remove the module.
3.- Disconnect the multipin connectors.
4.- Remove the screws of the element to be replaced.
5.- Replace the desired element.
6.- Fix the new element to the module.
7.- Connect the multipin connectors.
8.- Place the module and fix the screws.
Always use original ECLER GENUINE SPARE PARTS for your SMAC

4.6. External effect output, EFF

Each mixing channel of the SMAC PRO30 are provided with a rotatory potentiometer (8) to
send the signal to an external effect unit: sampler, rever,... The potentiometer controls the signal
level send to the external unit. The EFF output (27) must be connected to the input of the effect unit
and the output of the effect unit can be connected to the MIX input (26) or to a LINE input. The MIX
input is a direct access to the main mix bus and hence, no control is possible. But if a LINE input is
used, the signal can be processed as a normal sound source.

4.7. Crossfader assignement

The SMAC PRO30 has a crossfader with VCA and the adjacent channels (Channel 2 and
Channel 3) are permanently assigned to it. The remaining channel, can be assigned to any of the
crossfader extrems (A-B) by means of the 3-position XFADER lever switch (10). This switch can also
bypass the crossfader and send the signal directly to the mix bus.

4.8. Crossfader curve adjust:

Thanks to the VCA concept, it's now possible to modify the gain/attenuation behaviour of
the crossfader. The SMAC PRO30 provides this feature, enabling you to control the fade-in and
fade-out characteristics of the crossfader. The Crossfader knob XF SHAPE (12) at the housings
frontplate let you adjust the response curve from soft to hard independently so that you could
perform from sharp Scratch to smooth House techniques.

4.9. Effects: KILL, PUNCH.

The SMAC PRO30 have two groups of lever switches (15). Each group acts only on the
channel they are placed A or B. When the switches are used, the selected frequency range is
instantaneously eliminated. So, it is possible to mix the bass of a song (by eliminating the medium and
treble) with the medium and treble (by eliminating the bass) of another song.
The PUNCH switches (13) are also instantaneous. The music is instantaneously inserted if
the crossfader is closed (opposite site of the switch pressed). The level of the punched channel
depends on the channel fader.
The combination of these elements offers an incredible fan of possibilities for your
creativity.
7