THOMSON CT550I Instrucciones De Funcionamiento página 17

When you're not setting the time or the alarm, press button (3) or (4) to increase or
decrease the alarm volume by one level.
There are 5 volume levels, from the quietest to the loudest. The lowest level is
approximately 40 dB and the highest level is around 80 dB — with steps of 10 dB between
each level.
The volume level is displayed on the screen. The alarm's sound slowly increases,
reaching the set volume within 15 seconds.
3. Press the dimmer switch/repeat button (9) to adjust the brightness of the clock display
(20%, 100%, or off) in time mode. When the alarm sounds, press to snooze it for 9
minutes. The alarm will then sound again, 9 minutes later. The repeat light (11) will come
on.
The alarm will sound for 3 minutes if it is not repeated or dismissed. Press the alarm
button (2) to dismiss it when it sounds.
Note: The clock and alarm programmes have a back-up battery in the even of the power
supply being cut off (e.g. After a power cut, etc.). If the programmes are not backed up,
you'll need to replace the battery. See below.
Charging functions
1. Place your mobile phone on top of the device, in the centre.
2. The LED light (12) will illuminate in solid blue when the wireless charging is in progress.
If nothing is charging, it will remain red.
3. If a foreign metal object is detected in the charging zone, the LED light (12) will slowly
flash blue, and the charging function will disable.
Note: Your phone must support wireless charging. Otherwise, the LED light will flash blue to
signal an error.
USB-C charging function
1. Charge another device using the USB-C port (6) located to the rear of the alarm.
2. Use the adapter (7) if your charging cable has a USB-A plug.
Please note that the USB C port is designed to charge low power items such as smart watch
or earbuds. Any other product may temporarily cause adverse effects.
Note: The USB-C output functions at 5 V/1 A (max.).
Interior temperature function
This device has an interior temperature function. The probe is integrated into the power cable.
No action on your part is required. The temperature display is located to the right of your
display.
Changing the back-up battery
1. Remove the safety screw using a compatible screwdriver.
2. Using a tool, turn the cover of the battery compartment counter-clockwise, to align the two
guide triangles. You'll feel slight resistance.
- EN 17 -