Keyline 994 LASER Manual De Uso Y Mantenimiento página 50

7.4.0 Modify menu
The MODIFY MENU is used to modify the cut parameters for a key and
it also makes it possible to personalise some characteristics of the
key, according to the client's specific requirements.
How to proceed:
• From the key search sub-menu, select "
• This displays the technical sheet for the selected article and
makes it possible to change some of the key characteristics.
3 4 5 6 7 8
Options displayed:
1. With this button is possible to decode the key using the
selected key system.
2. With this button is possible to insert the cuts directly.
3. With the Cut Type button is possible to select between
the possible cut types for the selected key. For Flat keys
cut types are: Normal, Laser and Plane.
4. With the left arrow button is possible to scroll the spaces
moving to left direction.
16 Keyline S.p.A.
MODIFY AND CUT
5. With the right arrow button is possible to scroll the spac-
es moving to right direction.
6. With the minus button is possible to decrement the depth
of the highlighted tooth.
7. With the plus button is possible to increment the depth of
the highlighted tooth.
8. This makes it possible to select the depth increase or de-
".
crease rate when the + or - buttons are pressed. The availa-
ble options are: one STEP is either 0.1 mm or 0.01 mm.
9. With this button is possible to reset the modifications
made on the selected tooth.
10. With this button is possible to modify simultaneously all
the teeth.
• For further information select "
Note: The " " symbol makes it possible to save the selected
key in the list of bookmarks. See paragraph 6.2.0.
7.5.0 Key cut menu
Once the key to be copied has been searched using the relevant func-
tions in the Database menu, the programme will direct the user to the
CUT screen, that makes it possible to duplicate the desired key.
1
2
9 10
4 5
Options displayed:
1. With this button is possible to set the amount of copies
that need to be cut.
2. With this button is possible to save the key.
994 LASER
3. Starts the key cutting process.
4. With this button is possible to change the default materi-
5. With this button is possible to select the Jaw that has to
6. Displays the type of stop to be used to cut the key.
7.
" from the display.
8. With this button is possible to enable or disable the
• For further information select "
1
2
6 7 8
3
Man. cod. B409619FG
al. The selectable material are: BRASS, AlUMINIUM,
STEEL, NIKEL SILVER, CUSTOM. Each material has a ded-
icated set of parameters for the movement speed and
cutter speed for optimizing the quality of the cut and en-
sure the life of the cutter. The custom material can be
customized on the Parameters Panel of the Setup Menu.
be used to cut the key, only compatible Jaws will be se-
lectable.
With this button is possible to enable or disable the
measure of the dimension of the key.
measure of the width of the key, this measure is faster re-
spect of the complete measure and is useful to optimize
the cut procedure but when using blank keys with
precuts the complete measure is preferred .
" from the display.
Copyright by Keyline - Italy