Publicidad
N
L
.
.
.
---------------------------------------------------
Instructions for use
----------------------------------------------------
By pressing the button shown in the figure 2,
you will be able to control the functions of the
extractor.
To achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
the air flow is continuous and stable when
extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to
allow all fumes and odours to be expelled.
Cleaning and maintenance
----------------------------------------------------
Before
carrying
out
any
cleaning
maintenance
activities,
ensure
that
extractor is disconnected from the mains.
To carry out cleaning and maintenance,
follow the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished,
by means of special sprays (protecting the
non metallic parts). Once clean, leave it to
dry.
Notes: cleaning in the dishwasher with
aggressive detergents may blacken the
surface of metallic parts, without this affecting
its gas retaining properties.
N.B. The filter must be cleaned at least once
a month depending on how often the
extractor is used. It must be remembered that
grease is deposited in the extractor when
cooking, whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor,
paying
special
attention
to
the
grids.
Afterwards, dry it using a lint-free cloth.
Note:
* Never use metallic scouring pads or
abrasive products that could damage the
surface.
* Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
* To install the charcoal filter, disassemble
the lid, introduce the filter in the position
provided and reassemble the lid.
* The carbon filter lasts from three to six
months
depending
on
the
conditions of use.
* The activated carbon filter can neither be
washed
nor
regenerated.
exhausted, it must be changed.
* To replace the exhausted filter with a new
one, we will make in the same way that in
or
its assembly, previously extracting the
the
spent filter.
Changing Bulbs
* Remove the filters and the light bulbs will be
at sight.
* Take
care
to
disconnect
beforehand and that the bulbs to be
replaced are not hot.
* The maximum bulbs power is 40W.
Technical Information
(Fig. 3)
---------------------------------------------------
Dimensions: Width = 600/760/800/900 mm
Depth = 500 mm
Height = 150 mm
Electrical characteristics:
REFER TO RATING PLATE
particular
Once
it
is
the
mains
Publicidad
