Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
APPLICATIONS
You may use this product for the following purpose:
„ Charging compatible RIDGID™ 18 V battery packs
NOTICE:
If charge does not appear to initiate or appears
to stop charging the battery pack before reaching
full charge, check that charger is properly plugged
into a power supply (outlet) and that the power
supply is energized. If so, try charging a different
battery pack. If the different battery pack charges
properly, then return the battery pack that did not
charge properly. If a different battery pack does not
charge, return the charger and the battery pack.
Make returns to the nearest authorized service
center for service or replacement.
NOTICE:
Charge in a well-ventilated area.
DIAGNOSTIC FEEDBACK
LEDs provide feedback to indicate whether the battery pack
is charging, fully charged, or has an error.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
KEY HOLE HANGER
See Figure 1, page 7.
The charger has a key hole hanging feature for convenient,
space saving mounting. Screws should be installed so that
the center distance is 4.75 in.
PASS-THROUGH PLUG
See Figure 2, page 7.
The charger features one AC pass-through plug, allowing
you to connect an additional device to the same AC outlet
the charger is using.
CHARGING
See Figure 3, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time varies and is dependent upon the amp hour
capacity and charge level of the battery pack.
„ Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
„ Connect the charger to a power supply.
„ Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
„ Press down on the battery pack to be sure contacts on the
battery pack engage properly with contacts in the charger.
„ Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
„ The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
„ After charging is complete, the green LED will remain on.
„ When the battery pack is fully charged, remove it from
the charger.
4 — English
Publicidad
