Nuna Pruu Instrucciones página 14

2
- Press the harness adjustment button while pulling the shoulder
harnesses to the desired length (Pull from below the fixed shoulder pads
to lengthen). (33)
3
- Unlock the buckle of the harnesses by pressing the red button. (34)
Remove the infant insert when in forward facing mode.
4
- Place the buckle tongues against the magnetic area on the outer side of
the enhanced child restraint so that the tongues are held in place. (35)
5
- Rotate the enhanced child restraint seat to forward facing
child restraint indicator will show green. (36)
6
- Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured. (37)
Always keep child secured in harness and properly tightened by
removing any slack.
DO NOT use forward facing unless your child is at least 76cm AND 15
months old.
Detach & Assemble Soft Goods
Press the red button to disengage the buckle. (38)
Follow steps (39) - (44) to detach soft goods.
To re-attach the soft goods please repeat the above steps in reverse.
13
PRUU instructions
﹐
the enhanced
Cleaning and Maintenance
Please store the infant insert somewhere out of the child's reach.
Please wash the soft goods with cold water under 30°C.
DO NOT iron the soft goods.
DO NOT bleach or dry clean the soft goods.
DO NOT use undiluted neutral detergent, gasoline or other organic solvent
to wash the enhanced child restraint. It may cause damage to the enhanced
child restraint.
DO NOT twist the soft goods to dry with great force. It may leave the soft
goods with wrinkles.
Please hang dry the soft goods in the shade.
Please remove the enhanced child restraint from the vehicle seat if it will not
be in use for a long period of time.
NUNA International B.V. Nuna and all associated logos are trademarks.
14
PRUU instructions