Qlima PGW312 Instrucciones De Uso página 42

Step 4:
Slide (7) into (8) (see pic. 5)
Step 5:
Mount and fix (8) onto (9) by using the 4 provided bolts.
Make sure to also connect (7) using the provided longer bolt.
(see pic. 6)
Step 6:
Screw the 3 reflector support bolts to the top of (2) (see pic. 7)
Step 7:
Carefully remove all the blue plastic film from the reflector parts
Assemble the reflector according to pic. 8
Step 8:
Mount the reflector to (2) using the support bolts mounted in step 7.
Fasten the reflector with the 3 provided wingnuts. See pic. 9
Step 9:
Connect your regulator to your gas tube. (see pic. 10)
Step 10:
Position the gas cylinder into (9)
Connect your regulator to your gas cylinder. (see pic. 11)
Step 11:
Fasten the gas cylinder with the included fixation strap. (see pic. 11)
Step 12:
DANGER: ALWAYS perform a complete leakage check using soapy water (see
chapter "leak testing")
OPERATION
TO TURN ON THE HEATER:
a)
b)
c)
d)
e)
f)
g)
h)
4
42
Open the gas supply valve on your gas cylinder. Refer to Pic. 'control panel'
below: Ignitor button 2 is also the lid of the battery housing. Screw off the
ignitor button and position 1x AAA battery ("+" pole pointing towards you),
see pic. 12.
Press control button (1)
While pressing control button (1) turn it to position "MIN"
Keep pressing control button (1) for 15-30 seconds (*)
During the 15 – 30 seconds: press ignitor button 2 (*)
Release the ignitor button when the flame is ignited
30 seconds after ignition: the capacity of the heater can now be controlled by
turning the knob (1) between "MIN" and "MAX"
When heater is not lit: turn (1) to "OFF", wait 5 minutes, repeat the process b
to g.
(*) with a new gas cylinder or when the gas cylinder is replaced: it could take
longer than 15-30 seconds before the gas will enter the burning chamber. In
such cases: keep pressing the control button (1) for > 20-30 seconds then press
ignitor button 2.