Beper P101CAF001 Manual De Instrucciones página 11

Automatic Milk Frother Use Instructions
Note: Use whole milk, recommended milk temperature (5-10°C).
Plug the cord into a power outlet.
Press the "FUNCTION" button once; the indicator for Hot and Dense Foam (no. 1, Fig. B) will light up. Then
press the "ON/OFF" button once, and the appliance will start working. Once the frothing cycle is complete,
the appliance will turn off automatically.
Note: During operation, you can interrupt the frothing cycle by pressing the "ON/OFF" button once.
When the appliance has finished working, open the lid and pour out the frothed milk.
Caution: A minimum rest time of 3 minutes must be maintained between two continuous cycles;
otherwise, the appliance will enter auto-protection mode after 5 continuous operating cycles. The
indicator will flash, and the "ON/OFF" button will not activate. After about 5 minutes, the applian-
ce will enter standby mode, and you can continue to use it.
Notes: Clean the container according to the "Cleaning and Maintenance" section between two conti-
nuous cycles. Always turn off the appliance and unplug the cord when not in use.
Hot and Light Foam
Place the appliance on a flat surface.
Open the lid, insert the frothing whisk above the pin situated at the bottom of the container.
Fill the container with the desired amount of milk and put on the lid.
Note: The maximum amount of milk to add is 150 ml (Fig. C) to avoid milk spills after frothing. The
minimum amount of milk to add is 75 ml.
Note: Use whole milk, recommended milk temperature (5-10°C).
Plug the cord into a power outlet.
Press the "FUNCTION" button twice; the indicator for Hot and Light Foam (no. 2, Fig. B) will light up. Then
press the "ON/OFF" button once, and the appliance will start working. Once the frothing cycle is complete,
the appliance will turn off automatically.
Note: During operation, you can interrupt it by pressing the "ON/OFF" button once.
When the appliance has finished working, open the lid and pour out the frothed milk.
Caution: A minimum rest time of 3 minutes must be maintained between two continuous cycles;
otherwise, the appliance will enter auto-protection mode after 5 continuous operating cycles. The
indicator will flash, and the power button will not activate. After about 5 minutes, the appliance
will enter standby mode, and you can continue to use it.
Notes: Clean the container according to the "Cleaning and Maintenance" section between two conti-
nuous cycles. Always turn off the appliance and unplug the cord when not in use.
Heating only without frothing
Place the appliance on a flat surface.
Insert the frothing whisk above the pin situated at the bottom of the container.
Fill the container with the desired amount of milk and put on the lid.
Note: The maximum amount of milk to add is 300 ml (Fig. C) to avoid milk spills after heating. The
minimum amount of milk to add is 75 ml.
Note: Use whole milk, recommended milk temperature (5-10°C).
11
EN