Beper P101CAF001 Manual De Instrucciones página 12

Automatic Milk Frother Use Instructions
Plug the cord into a power outlet.
Press the "FUNCTION" button three times; the indicator for Milk Heating Without Foaming (no. 3, Fig. B) will light
up. Then press the "ON/OFF" button once, and the appliance will start working. Once heating is complete, the
appliance will turn off automatically. When it has finished working, open the lid and pour out the hot milk.
Caution: A minimum rest time of 3 minutes must be maintained between two continuous cycles;
otherwise, the appliance will enter auto-protection mode after 5 continuous operating cycles. The
indicator will flash, and the power button will not activate. After about 5 minutes, the appliance will
enter standby mode, and you can continue to use it.
Notes: Clean the container according to the "Cleaning and Maintenance" section between two conti-
nuous cycles. Always turn off the milk frother and unplug it when not in use.
Cold Frothing
Place the appliance on a flat surface.
Open the lid, insert the frothing whisk above the pin situated at the bottom of the container.
Fill the container with the desired amount of milk and put on the lid.
Note: The maximum amount of milk to add is 150 ml (Fig. C) to avoid milk spills after frothing. The mini-
mum amount of milk to add is 75 ml.
Note: Use whole milk.
Plug the cord into a power outlet.
Press the "FUNCTION" button four times; the indicator for Cold Frothing (no. 4, Fig. B) will light up. Then press
the "ON/OFF" button once, and the frothing whisk will rotate to froth the milk, but the heating element will not
heat. Once cold frothing is complete, the appliance will turn off automatically.
Note: During operation, you can interrupt it by pressing the frothing button once.
When the appliance has finished working, open the lid and pour out the milk froth.
Caution: A minimum rest time of 3 minutes must be maintained between two continuous cycles;
otherwise, the appliance will enter auto-protection mode after 5 continuous operating cycles. The
indicator will flash, and the power button will not activate. After about 5 minutes, the appliance will
enter standby mode, and you can continue to use it.
Notes: Clean the container according to the "Cleaning and Maintenance" section between two conti-
nuous cycles. Always turn off the appliance and unplug it when not in use.
Cleaning and Maintenance
Always unplug the appliance from the power outlet and let it cool before cleaning.
Caution: Never immerse the container, power cord in water, or allow moisture to come into contact
with these parts. Do not wash any parts in the dishwasher. This could permanently damage the ap-
pliance and void the warranty.
Wash the lid with water and a mild detergent. The lid is not dishwasher safe. Rinse thoroughly and dry.
Remove the frothing whisk and wash it thoroughly with lukewarm water.
Clean the inside of the container with a combination of mild detergent and water, then wipe it with a soft, damp
cloth. Clean the outside of the container with a soft, damp cloth or detergent, avoiding the use of corrosive cle-
aners.
Note: Do not use chemical, abrasive, steel, or wooden cleaners to clean the outside of the appliance to
avoid losing its shine.
12