osann Eno360 SL Instrucciones De Instalación página 29

1 . Set the child car seat to seat position 1 and rotate it so that it faces seat position R in a
rear-facing orientation.
2 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
3 . Fold out the stand below the child car seat. Pull the rotation lever and slide the stand further
forward.
4 . Guide the Isofi x connectors onto the Isofi x anchor points on the vehicle seat and ensure that
they lock into position.
5 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators are showing green.
6 . Adjust the height of the support leg and ensure that this is fully in contact with the footwell
of your vehicle.
7 . Ensure that the indicator on the support leg is switched to green.
8 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
9 . Unfasten the belt buckle on the child car seat and place the belts over the outside of the seat.
10 . Put your child in the child car seat.
11 . Adjust the height of the headrest as described above.
12 . Fasten the belt buckle again until you hear a click.
13 . Pull the front adjustment strap to tighten the belts.
14 . Ensure that the straps are not twisted.
15 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
- 29 -
EN