Ego Power+ PAD1800E Manual página 5

OPERATION
WARNING:
To reduce the risk of electric shock
connect only one electrical equipment to the socket
outlet.
APPLICATIONS
You may use this product for the purposes listed below:
◾
Supplying power for small AC devices via AC output
port.
◾
Supplying power for compatible small USB electronics
via USB-A or USB-C output ports.
◾
Providing light in low light conditions or serve as an
emergency light beacon.
INSTALLING/REMOVING BATTERY PACK (Fig. B)
Fully charge the battery pack before first use.
To attach
Align the mounting slots on the power inverter with the ribs
on the battery pack, then move the power inverter towards
the battery pack until it snaps into position.
To remove
Hold the battery pack with one hand and pull the power
inverter with the other hand to separate them.
TURNING POWER INVERTER ON/OFF (Fig. C)
1. Install the battery pack.
2. To turn the power inverter on, press the power
button and the button will illuminate green, which
indicates the power inverter is activated.
3. To turn the power inverter off, press the power
button again and the green light will turn off, which
indicates the power inverter is deactivated.
NOTE:
◾
If there is no device connected, the power inverter will
shut off automatically in 2 hours.
◾
If devices are connected but the USB output current
is not more than 2W and the AC output power is less
than 5W, the power inverter will shut off automatically
in 2 hours.
C-1 Power Button
LED LIGHTS (Fig. D)
The power inverter is equipped with one LED light located
on the top of the unit. The light provides light in low light
conditions or serves as an emergency light beacon.
The LED light could be turned on whenever the power
inverter is activated or deactivated.
◾
To turn the LED light, press the LED button. The light
will turn on in low brightness mode.
◾
Press the LED button again to switch to high
brightness mode.
◾
Press the LED button the third time to switch LED light
is off.
In any mode, press and hold the LED button for more
than 1 second and the light will switch into flashing,
"EMERGENCY" mode. Press the LED button again, the
light will shut off.
D-1 LED Button
56 VOLT POWER INVERTER — PAD1800E
D-2 LED Lights
5
EN