Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Sleep (air conditioner mode only)
When the sleep function is activated, the air conditioner increases the temperature to rise
gradually to accommodate the drop in body temperature that occurs when you fall asleep.
For example:
1
hour
The air conditioner runs at the preset temperature.
st
2
hour
The air conditioner increases 1°C.
nd
3
hour
The air conditioner increases another 1°C and then maintains this
rd
temperature until the sleep function is turned off.
•
When the air conditioner is on, press the
will change to low speed and the sleep indicator light will turn on.
•
When you select the sleep function via the remote control, the sleep icon
displayed on the remote control's screen.
Swing (all modes)
•
Press the
button to swing the fan through 75 degrees. Press the
it off. When you turn on the swing function using the remote control, the swing icon
will display on the remote control.
Frost protection
When operating the unit at low room temperatures, frost may build up on or around the
cooling elements. The unit will detect if the internal temperature is below -1°C for more
than 3 minutes. Then it will automatically stop the compressor and run the fan. During this
time, the power indicator will flash. Once the internal temperature has risen to 7°C or above,
the power indicator light will stop flashing, the fan will turn off and restart the compressor.
Overload protection
Should the unit turn off due to a power cut or overheating, you must wait 3 minutes before
restarting it. If the plug is removed, all programmed timer settings will be lost and the unit
will start in the default mode.
The overload protection may trip if the temperature goes above the optimal working temperature
of 35°C.
NOTE: If any windows or doors are left open whilst the unit is in air conditioning
or dehumidifying mode and the relative humidity is above 80%, condensation may
drip from the cold air outlet.
Remote control
The remote control buttons work the same as the control panel buttons, except for the following:
1.
There is no multiple mode button (
mode directly by pressing the
2.
The
button can be pressed to toggle between Celsius and Fahrenheit temperatures.
Point the remote control at the receiver on the front of the unit. Make sure you use the remote
control within 5 metres of the unit (with no obstacles in between). If the remote control is not
working, move it closer to the unit or change the batteries.
button to activate the sleep function. The fan
) on the remote control. Instead, you need to select the
(cool),
(dry) or
(fan) button on the remote control.
31
EN
will be
button again to turn
Publicidad
