Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Water supply
A proper water pressure for this Laundry Hub is between 20-116 psi (137-800 kPa). Water pressure less than
20 psi (137 kPa) may cause the water valve to not close completely, or it may take longer to fill the drum,
causing the Laundry Hub to turn off. Water taps must be within 4 ft. (122 cm) from the rear of the Laundry
Hub so that the provided inlet hoses reach the Laundry Hub.
To reduce the risk of leaks:
• Make sure water taps are easily accessible.
• Turn off the taps when the Laundry Hub is not in use.
• Check for any leaks at the water inlet hose fittings on a regular basis.
CAUTION
Before using the Laundry Hub for the first time, check all connections at the water valve and taps for any
leaks.
Drain
Samsung recommends a standpipe 18 in. (460 mm) high. The drain hose must be connected through the
hose clip to the standpipe, and the standpipe must fully cover the drain hose.
Dryer requirements
Ducting requirements
Weather hood type
No. of 90° elbows
0
1
2
3
NOTE
* Use a 4-inch (10.2 cm) diameter rigid aluminum or galvanized steel duct.
28
English
Untitled-1 28
Recommended
4" (10.2 cm)
Rigid
80 ft. (24.4 m)
68 ft. (20.7 m)
57 ft. (17.4 m)
47 ft. (14.3 m)
Use only for short-run
installation
2.5" (6.4 cm)
Rigid
74 ft. (22.6 m)
62 ft. (18.9 m)
51 ft. (15.5 m)
41 ft. (12.5 m)
2023-11-09( )
11:53:35
Publicidad
