Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
36
English
Untitled-1 36
3. Put the other ends of the hoses into a bucket, and
then open the water taps for 10 - 15 seconds to
remove impurities. When done, close the taps.
4. Attach the water hoses to the hot and cold water
inlets on the back of the Laundry Hub, and then
hand tighten the water hose fittings until they are
tight. Then, use pliers to tighten the fittings by an
additional two-thirds of a turn.
NOTE
If you do not want to use the hot water supply hose,
attach the water intake cap to the hot water supply
intake. When you do a wash, tap Temp. to select 1 (Tap
Cold).
5. Open the water taps, and check for leaks.
2023-11-09( )
11:53:37
Publicidad
