Publicidad
Idiomas disponibles
Idiomas disponibles
Care for preventing freezing
• Install the Laundry Hub in an area where the temperature does not drop below zero degrees Celsius.
• Before using the Laundry Hub, make sure the drain hose is not frozen. A frost inside the dryer may cause
noise during operation, but it is temporary and is not a sign of product failure.
• If you connected the long drain hose for direct draining, water remaining inside the hose can freeze in
winter. Make sure there is no water left inside the hose after use.
• If the drain hose has frozen, wrap the hose with a towel soaked in warm water for approximately ten
minutes to thaw it.
• If the draining fails even after thawing the drain hose, the ice inside of the Laundry Hub might be the
cause so operate the defrosting function.
Defrosting your Laundry Hub
The Laundry Hub may freeze when it drops below 0 °C.
1. Turn off the Laundry Hub, and unplug the power cord.
2. Pour warm water over the water tap to loosen the water hose.
3. Disconnect the water hose, and soak it in warm water.
4. Pour warm water into the drum and leave it for about 10 minutes.
5. Reconnect the water hose to the water tap.
NOTE
If the Laundry Hub still doesn't operate normally, repeat the above steps until it operates normally.
Care against an extended time of disuse
Avoid leaving the Laundry Hub unused for an extended time. If this is the case, drain the Laundry Hub and
unplug the power cord.
1. Turn on the Laundry Hub and select the washer.
-
The washer is selected as a default.
2. Turn the Navigation dial to select Denim.
3. Empty the drum, and then touch and hold
4. When the cycle is complete, close the water tap and disconnect the water hose.
5. Turn off the Laundry Hub, and unplug the power cord.
6. Open the door to let air circulate through the drum.
Untitled-1 81
.
English 81
2023-11-09( )
11:53:46
Publicidad
