Kenmore 911.41475 Manual De Instrucciones página 19

OPERATION
OvenControl, Clock and Timer
Your new control has a series of tones
that will sound at different times These
tones may sound while you set the
control for an oven function, or at the
end of the oven function It will also
alert you there may be a problem with
the functions Below are the types of
tones and a brief description of each
TONES WHILE SETTING THE
CONTROL--When you press a touch
pad you will hear a beef This beep will
let you know you have placed enough
pressure on the pad to activate it
END OF TIMED CYCLE TONE--At
the end of a timed cooking function, you
will hear 3 short beeps followed by 1
beep every 6 seconds This 6 second
beep will continue to sound until the
CLEAR/OFF pad is pressed, or you
may select the special feature to cancel
this 6 second beep from sounding at
the end of future cycles
TO CANCEL THE 6 SECOND
BEEP
1. Press and hold the BAKE and
BROIL pads, at the same time,
for 3 seconds, until the display
shows "SF",
2. Press the KITCHEN TIMER
ONIOFF pad The display will show
"CON BEEP" (continous beep)
3. Press the KITCHEN TIMER
ON/OFF pad again The display will
show "BEEP" (beep canceled)
4. Press the START pad,
If you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and press
start,
ATTENTION TONE
This tone wilt sound if you make an error
or an oversight is made while setting an
oven function,
Examples would be:
a. Setting a clean cycle and the oven
door is not properly closed
b. Setting a timed function and the time
being set is invalid,
c. Pressing an additional function pad
without first setting a temperature or
time
Any of these can be quickly identified
by watching the display
PREHEAT TONE--When you set an
oven temperature, the oven
automatically starts to heat, When the
temperature inside the oven reaches
the temperature you have set. a tone
will sound to let you know the oven is
ready for baking,
If you set an oven function and the
control beeps while the display is
flashing "F" and a number "F-4" or
letter "FI" there may be a problem with
the control, Simply press the
CLEAR/OFF pad and wait about an
hour_ Try setting the function again, tf
the code repeats, write down the code
and call for service Tell the technician
what code was flashing
19