Publicidad
Idiomas disponibles
Idiomas disponibles
C
aring For Your Dryer
Ventilation Grille and Cool Air Inlet
Grille
Use a vacuum cleaner to clean the front
ventilation grill and the cool air inlet in the back.
Failure to remove any lint or dirt buildup will
reduce air flow and increase energy
consumption and drying times.
Note
The warm air is exhausted through the
ventilation grill.
Condensed Water Drain
Condensed water is pumped to the reservoir which
must be emptied every load. If a household drain is
available, this water can be pumped down the drain
so the reservoir is not used.
1. Before connecting the
external drain hose,
remove the foam pad
located at the back of
the dryer (on the right
side as you face the
rear of the dryer).
2. Slide the drain
connection out.
3. Disconnect the hose
that goes up to the
reservoir.
24
4. Connect the external
drain hose included
with the dryer. Route
this hose to a
permanent drain and
secure the hose so it
cannot come loose.
Note
Make sure to disconnect the correct hose.
DO NOT disconnect the hose on the back
at the bottom of the dryer.
Doing so will cause leakage.
Moisture Sensor
This sensor is used by the control to sense the
moisture remaining in the clothes. If the sensor
becomes dirty or coated the control will not be
able to sense the moisture and the dryer will shut
off before the clothes are dry.
Clean the sensor bars as shown below to
maintain optimum performance of the SENSOR
DRY cycles.
F
Publicidad
