Velleman INR11190 Manual Del Usuario página 5

There are no us
Refer to an aut
• Familia arise yourself wit
it.
• All mod difications of the
• Only us se the device for
unauth horised way will v
4. Fea atures
• 4 digits s LCD
• auto po ower-off
• comes with: storage bo
manua l
• optiona al telescopic tripo
5. Use
Refer to t he illustrations o
• Remov ve the sensor cov
device and sliding the c
• Press t he TYPE/ON/O
±2s to switch it off. The
thermo ocouple) as it was
• The de vice powers off a
thermo ocouple-mode. To
button while switching t
backlig ght switches on.
• Press t he UNIT button
• Press t he
it off.
IR-mode e
• Switch on the meter. If
the TY YPE/ON/OFF bu
• Point th he IR-sensor tow
[C]. Id deal measuring ra
surface e temperature is
releasin ng the SCAN/H-
Note: see e §7 for more use
• To faci litate measuring,
Press t he LASER-butto
toward s the target.
21.01.2010
Protect th he device against
ser-serviceable p
thorized dealer fo
h the functions o
device are forbid
its intended pur
void the warranty
ox, wristlet, K-typ
od (not incl.): CA
on pages 2 and 3
ver [1] by releas
cover upwards.
OFF button to swi
e meter will start
s in when it was
automatically afte
o disable auto-po
the device on. Re
to switch betwee
-button to o switch on the b
f it starts up in th
tton again to ena
wards the target a
ange is between
shown [E]. End
-button [A].
eful information.
, the thermomete
n to enable the l
DVM809 90
t extreme heat a
parts inside the d
or service and/or
of the device befo
dden.
rpose. Using the d
y.
pe thermocouple
AMB17
3 of this manual.
ing the screw at
tch the device on
t up in the same
switched off.
er ±25s in IR-mo
ower off, press an
elease the Laser
en °C and °F.
backlight [I]. Pre
hermocouple mod
able IR-mode ([A
and press the SC
25 and 250mm (
the measuring s
er can produce a
aser-beam (see
5
Rev. 0
nd dust.
device.
spare parts.
ore actually using
device in an
, batteries, user
the back of the
n. Press and hold
mode (IR or
ode or ±20min in
nd hold the Lase
r-button when th
ess again to switc
de [B] then pres
A] is shown).
CAN/H-button
(1" ~ 10"). The
ession by
laser-beam.
[H]) and point it
©Velleman
01
g
d
n
er
e
ch
s
t
nv