Velleman AVMOD19 Manual Del Usuario página 8

4. Connect the IR extender connector to the IR remote output port [D]. Place
the IR LED [L] in front of the IR receiver of the signal transmitting device,
maximum distance ± 50 cm (± 20"), angle +/-15°.
5. Plug the power plug of the included AC power adaptor [K] into the power
connector [F]. Only use the included adaptor or one with the same
specifications.
6. Make sure the power switch [C] is in the OFF-position and plug the adaptor
into a suitable mains outlet.
Note: Make sure the power adapter is easily accessible. Always disconnect the
mains power when the device is not in use.
Receiver [6]
1. Use the SCART-to-RCA A/V cable marked with RECEIVER (included) or use
an appropriate S-video cable (not included).
Note: When using an S-video cable on the transmitter side, an S-video cable
must also be used on the receiver side.
2. Connect the RCA video connector (yellow) to the video connector [H] and
connect the audio connectors (red, white) to the audio connectors [I]
resp. [J]. When using an S-video cable, simply connect it to the S-video
connector [G].
3. Connect the SCART connector to a SCART input connector or connect the free
end of the S-video cable to the S-video output port of a TV, monitor... (not
included).
4. Plug the power plug of the included AC power adaptor [K] into the power
connector [F]. Only use the included adaptor or one with the same
specifications.
5. Make sure the power switch [C] is in the OFF-position and plug the adaptor
into a suitable mains outlet.
Note: Make sure the power adapter is easily accessible. Always disconnect the
mains power when the device is not in use.
7. Operation
1. Switch on the receiver and transmitter [C].
2. Fold the antennas upwards and position them in such a way that the side with
the grooves of the receiver and transmitter antennas face each other [7].
This will guarantee best performance.
Notes:
The antenna does not rotate 360°. Do not force or rotate past the
o
protrusion or permanent damage will occur.
Avoid obstacles between the antennas as this will decrease performance.
o
Keep the distance from transmitter to receiver antenna as short as
o
possible.
3. Use the channel selector switch [B] to set the channel. Select a channel
depending on noise or interference conditions. Always set the same channel
on transmitter and receiver.
4. Point the remote control towards the receiver (see [8]) to control the
transmitting device(s). In case interference with other IR devices is noticed,
set the remote frequency selector [E] in the other position. In A-mode, the
carrier frequency is 38 kHz; in B-mode 56 kHz.
V. 02 – 17/09/2012
AVMOD19
8 ©Velleman nv