Alpina KPT-2402D Manual De Instrucciones página 7

REMOTE CONTROL
NOTE:
The button cell in the battery compartment of the remote control has
been secured with a foil for transport. This will extend the durability of
the battery. Before initial use please remove this foil so that the remote
control is ready for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there are no
obstacles placed between it and the sensor on the appliance.
Changing the Battery of the Remote Control
If the range of the remote control is reduced during use, please
proceed as follows:
1. Open the battery compartment on the bottom of the remote
control by holding the lever inwards and pulling out the battery
compartment.
2. Replace the button cell with a battery of the same type (CR2025).
Ensure correct polarity.
3. Then close the battery lid.
NOTES FOR USE
Connected Load
The appliance supports a power input of 2000 W.
CAUTION: Overload
• When using an extension cord, it must have a cable cross-section
of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appliance is too
powerful.
• Do not connect any other powerful appliances to the same electric
circuit.
Safety Switch
Your fan heater features a safety switch that disconnects the power
supply in case the appliance falls over. The safety switch prevents
hazards caused by overheating.
CAUTION:
Place the appliance on a smooth, horizontal surface. Avoid carpets in
order to prevent failure of the safety switch.
NOTE:
As soon as the safety switch has been activated, the appliance must
be set and switched on again.