High Pressure - Craftsman 580.752070 Instrucciones De Uso

How to Stop Your CJeaningSystem
1= Reieasespray gun trigger and let engine idte for two
minutes.
2. Move throttie to SLOW position, then STOPposition.
WARNING
,,_ Backfire, fire or engine damagecouId occur.
o DONOTstope%ine bymovingchokeleverto "Cheke"position.
3. ALWAYSpoint spray gun in a safe direction and squeeze
spray gun trigger to releaseretained high water pressure.
Jt_PORTANT:Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WANNING
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, ieading to serious injury and
)ossibieamputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
, Keephigh pressurehoseconnected to purnpand spraygun
whilesystemis pressurized.
o ALWAYS pointspraygun in safedirectionand squeeze spray
gun trigger,to release high pressure everytime you stop
engine.Engage trigger lockwhennot in use.
4. Engagetrigger iock on spray gun when not in use.
Hew ts Use Accesssry Tray
The unit is equipped with an accessory tray with piaces to
store your ProjectPro@nozzles, HydroFoam
TM
iauncher, spray
gun and nozzleextension. There is aiso a hook at the front of
the accessory tray to hold your high pressure hose. Identify
ali accessories with the iiiustration on page 6.
NOTE:The extra hoie in the tray is for storing a utiiity brush.
The extra clip in the tray is for storing a turbo nozzle.The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place nozzle extension through hole on accessory tray,
as shown.
.
3.
4.
.
Mace spray gun through hole on accessory tray on right
side of unit.
Insert multi-coIored ProjectPro@nozzles in spaces
provided in accessory tray.
Insert HydroFoam
TM
iauncher in space provided in
accessory tray next to the multi-colored ProjectPro@
nozzles.
Hang high pressure hose oil hook attachedto accessory
tray oll front of tray as shown.
Hew ts Use PrsjectPrs@ Hszz!e System
The quick-connect on the nozzle extension atiows you to
switch between three different ProjectPro@system nozzles.
ProjectPro@nozzles can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
ProjectPro® nozzles vary the pressure and spray pattern as
shown.
High Pressure
Delicate General Max
40° Yellow 15° Orange 0° Red
2350 PSI 2675 PSI 3000 PSi
2.7 GPM 2.5 GPM 2.3 GPM
Fellew these iestructiees te changePrejectPre@ nezzles:
1. Engagetrigger lock on spray gun.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underlying tissues, ieading to serious injup/and
}ossible amputation.
o NEVER exchange ProjectPro®nozzles withoutlockingthe
triggerlock on the spraygun.
• DONOTtwist ProjectPro®nozzles whilespraying.
2. PuIi back coiiar on quick-connect and puli current
ProjectPro@nozzle off. Store ProjectPro@nozzlesin
holder provided oll the accessory tray.
13