Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16. Control Fixtures by Manual
1.
Select the desired fixtures with the number but-
tons (1-8) and the PAGE button (PAGE A: 1-8,
PAGE B:9-16, PAGE C:17-24).
Move the faders and/or PAN/TILT wheels to ad
2.
just the DMX output values.
3.
In Step 2, fixtures can be selected one by one; Al-
ternatively, you can select more fixtures in a single opera-
tion. For example, to select Fixture 1-8, you can press and
hold the number button 1 and then press the number
button 8, Fixture 1-8 will all be selected. The same can be
applied to deselect fixtures.
17. H/S/V control
1.
HSV control, all fixtures must be patched correct
ly. (Refer to "01. Patch fixture".)
2.
This function is mainly to control led lights.
3.
H knob: Hue, rotate the knob, will control led
light RED/GREEN/BLUE color mixing
4.
S knob: Saturation, mixed color saturation.
5.
Vknob: Brightness, mixed color brightness.
18. Movement
There are 12 built-in movements in Show Design 3. 8 of
them are for moving heads and the rest 4 are for LED fix-
tures. Before running a movement, all fixtures must be
patched correctly. (Refer to "01. Patch fixture".)
1.
Select the desired fixtures with the number but-
tons (1-18) and the PAGE button (PAGE A: 1-8,
PAGE B:9-16, PAGE C:17-24)
2.
Press MOVEMENT to activate the mode.
3.
Select a desired MOVEMENT with the number
buttons (1-12). Movement 1-8 is for the pan/
tilt movement of moving heads. "MOVEMENT
RANGE" is 0-100% adjustable; "MOVEMENT OFF
SET" is 0-255 adjustable; "MOVEMENT SPEED"
is to adjust the movement speed and "DELAY LEV-
P. 10
NAVIGATOR SMART RDM
ENGLISH VERSION
EL" is to adjust the delay level from fixture to
fixture, the more fixtures you have the greater
level you need. Press SWAP to switch between the
adjustable parameters.
Movement 9-12, non-adjustable, is for R/G/B ef-
fects of LED fixtures.
19. Editing
Press and hold REC for 2 seconds to activate or inactivate
Editing mode.
Scene Editing
Channels and movements can be edited in a scene
Activate Editing mode.
1.
Select the desired fixtures with the number but-
tons (1-18) and the PAGE button(PAGE A: 1-8,
PAGE B:9-16, PAGE C:17-24) .
2.
Move the faders and/or wheels to adjust the DMX
output values. Movements can also be included.
3.
Press REC to get ready to save.
4.
Press SCENE and then press a number button to
save the scene. There are three pages (Page A and
B,C) to save the scenes. Once a scene is saved
successfully,allLED indicators will blink3 times.
5.
Repeat Step 2-5 to edit another scene.
Chase Editing
Channels, scenes and movements can be edited in a
chase.
1.
Activate Editing mode.
2.
Press CHASE (indicator on).
3.
Select a number button for the chase.
4.
Move the faders and/or wheels to adjust the DMX
output values. Scenes and/or movements can
also be included.
5.
Press REC to save the current step.
6.
Repeat Step 4-5 to edit a new step. You can rotate
Publicidad
Tabla de contenido
