^Ml these things are normal:
^
The oven causes
interference with my TV.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, blow dryers, etc.. It does not
indicate a problem with your oven.
The oven light dims.
When cooking with a power other than P10 (HIGH), the oven must cycle to
obtain the lower power levels. The oven light wiil dim and clicking noises
can be heard when the oven cycles.
Steam accumulates
on the oven door and warm
air comes from the oven
vents.
During cooking, steam and warm air are given off from the food. Most of
the steam and warm air are removed from the oven by the air which
circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
I accidentally ran my
Running the oven empty for a short time will not damage the oven,
microwave oven without
However, we do not recommend operating the microwave oven
^ any food in it.
without any food in it.
PROBLEM
POSSIBLE CAUSE
ACTION
-
Oven will not turn on.
r The oven is not plugged in
Remove plug from outlet, wait
S
[ securely.
10
seconds and reinsert.
[ Circuit breaker or fuse is
Reset circuit breaker or replace
I tripped or blown.
fuse.
There is a problem with the
Plug another appliance into the
outlet.
outlet to check if it is working.
1 The door is not closed completely.
Close the oven door securely.
Sfarf Pad was not pressed after
Press Start Pad.
programming.
Another program is already
Press Stop/Reset Pad to
entered into the oven.
cancel the previous program
and enter new program.
The program is not correct.
Program again according to the
Operating Instructions.
Stop/Reset Pad has been pressed
Program oven again.
accidentally.
_
The Glass Tray wobbles.
When the oven is operating,
there is noise coming from
the Glass Tray.
The word "Lock" appears in
the Display Window.
The Glass Tray is not positioned
properly on the Roller Ring or there
[ is food under the Roller Ring._
The Roller Ring and oven bottom
are dirty.
Take out Glass Tray and Roller Ring. Wipe
with a damp cloth and reset Roller Ring and
Glass Tray properly._
Clean according to Care of Your Microwave
Oven.
Function Key Pad has been activated
Refer back to Function Pad Operation on page 9.
-
17
-