Hoover Hw 48Amc/1-S Manual De Instrucciones página 74

- Press the button once to activate the
delay start and then press it again (or
hold it) to set the desired delay. The
delay increases each time the button is
pressed up to 24 hours, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
The option buttons should be selected
before pressing the START/PAUSE
button.
OPTIONS button
This button allows you to choose between
three different options:
- PREWASH
l
This option allows you to make a prewash
and it is particularly useful for heavily
soiled loads (can be used only on some
programmes as shown in the table of
programmes).
l
We recommend you use only 20% of the
recommended quantities shown on the
detergent pack.
- EXTRA RINSE
l
This option allows you to add one rinse at
the end of the washing cycle and is useful
for people with delicate and sensitive
skin, for which a small amount of
detergent residue can cause irritations or
allergies.
l
It is advisable to also use this function for
the children clothes and for the washing
of heavily soiled items, which requires a
lot of detergent to be used, or for the
washing of toweling items whose fibres
mostly have the tendency to hold the
detergent.
- HYGIENE +
Activated when
temperature. This
cleaning of your clothes by maintaining the
same temperature for the whole wash.
If an option is selected that is not
compatible
programme then the option indicator
light first flashes and then goes off.
RAPID / STAIN LEVEL button
This button allows you to choose between
two different options, depending on the
selected programme.
- RAPID
The button
you select the CARE (14/30/44 Min.)
programme on the knob and allows you to
select one of three durations indicated.
- STAIN LEVEL
l
Once the programme has been selected
the wash time set for that programme will
be automatically shown.
l
This option allows you to choose between
3 levels of wash intensity modifying the
length of the programme, depending
on how much the fabrics are soiled (can
only be used on some programmes as
shown in the table of programmes).
74
you set 60°C
option allows
with the selected
becomes active
of
deep
when